Compaq MP4800 - Manual (Page 19)

2–8 Compaq iPAQ Microportable Projector MP4800 User’s Guide
Using the Projector
4. Power on your source (computer, Pocket PC, VCR, etc.) and
launch the software application being used to display images
on the projection screen. If applicable, press the Function key
on the computer designated for external display.
✎
If there is a long delay between the time the startup screen
displays and the time the software application is launched, the
lamp may shut off and the projector will automatically go into
standby mode. If this happens, press the
Standby button 3 to
power on the lamp.
✎
When the startup screen disappears, the video from the attached
computer displays. If there is no incoming video, the “No Source
Found. Please Check Signal Cable” message will display on the
projection screen.
261794-001.book Page 8 Tuesday, January 22, 2002 2:20 PM