Compaq MP4800 User Manual
Page 66
8–6
Compaq iPAQ Microportable Projector MP4800 User’s Guide
Troubleshooting
Lamp burns out or makes a
popping sound
When the lamp reaches its end of life, it
will burn out and may make a loud
popping sound. If this happens, the
projector will not turn back on until the
lamp module has been replaced.
Contact your local Compaq authorized
dealer, seller, or reseller to purchase a
replacement lamp module. To replace
the lamp, follow the procedures in the
“Replacing the Projector Lamp Module”
section of Chapter 7.
Projector suddenly shuts down and
the power button LED blinks rapidly
An over-temperature event has been
detected. This usually occurs when
either the airflow to the unit has been
obstructed or a fan has failed. If airflow
is obstructed, remove the obstruction,
unplug the projector, re-plug the
projector, and restart. If a fan has failed
or an over-temperature event occurs a
second time, have the projector
serviced or repaired.
Speaker does not operate
1. Make sure the audio cable is
correctly connected to the projector
and the audio source.
2. Make sure the audio source is
operating properly.
3. Make sure the
Mute
button on both
the remote control and the audio
source is off.
Troubleshooting
(Continued)
Problem
Solutions
261794-001.book Page 6 Tuesday, January 22, 2002 2:20 PM