Dell POWEREDGE M1000E - Manual (Page 1030)

1030 Configuring RIP
RIP Configuration Example
This example includes four PowerConnect switches that use RIP to
determine network topology and route information. The commands in this
example configure Switch A shown in Figure 35-6.
Figure 35-6. RIP Network Diagram
To configure the switch:
1 Enable routing on the switch
console#config
console(config)#ip routing
2 Create VLANs 10, 20, and 30.
console(config)#vlan 10,20,30
3 Assign an IP address and enable RIP on each interface. Additionally, the
commands specify that each interface can receive both RIP-1 and RIP-2
frames but send only RIP-2 formatted frames.
console(config)#interface vlan 10
console(config-if-vlan10)#ip address 192.168.10.1
255.255.255.0
console(config-if-vlan10)#ip rip
VLAN 20
192.168.20.1
VLAN 10
192.168.10.1
Switch A
VLAN 30
192.168.30.1
L3 Switch
L3 Switch
L3 Switch