What is rmon – Dell POWEREDGE M1000E User Manual

Page 402

Advertising
background image

402

Monitoring Switch Traffic

• When a sample is taken, the counter indicating how many packets to skip

before taking the next sample is reset. The value of the counter is set to a

random integer where the sequence of random integers used over time is

the Sampling Rate.

Counter Sampling

The primary objective of Counter Sampling is to efficiently, periodically

export counters associated with Data Sources. A maximum Sampling Interval

is assigned to each sFlow instance associated with a Data Source.
Counter Sampling is accomplished as follows:

• sFlow Agents keep a list of counter sources being sampled.
• When a Packet Flow Sample is generated the sFlow Agent examines the

list and adds counters to the sample datagram, least recently sampled first.

Counters are only added to the datagram if the sources are within a short

period, 5 seconds say, of failing to meet the required Sampling Interval.

• Periodically, say every second, the sFlow Agent examines the list of counter

sources and sends any counters that must be sent to meet the sampling

interval requirement.

The set of counters is a fixed set.

What is RMON?

Like sFlow, RMON is a technology that enables the collection and analysis of

a variety of data about network traffic. PowerConnect

M6220/M6348/M8024/M8024-k switch software includes an RMON probe

(also known as an RMON agent) that collect information and analyze

packets. The data that is collected is defined in the RMON MIB, RFC 2819.
RMON is defined in an Internet Engineering Task Force (IETF) specification

and is an extension of the SNMP MIB. You can view the RMON information

locally on the switch or by using a generic RMON console on a network

management station (NMS). SNMP does not need to be configured on the

switch to view the RMON data locally. However, if you use a management

station to view the RMON data that the switch collects and analyzes, you

must configure the following SNMP settings:

• Set up the SNMP community string to be used by the SNMP manager at a

given IP address.

Advertising