Dell POWEREDGE M1000E - Manual (Page 1072)

1072 Configuring IPv6 Routing
Configuring IPv6 Interface Settings
Beginning in Privileged EXEC mode, use the following commands to
configure IPv6 settings for VLAN, tunnel, or loopback interfaces.
Command Purpose
configure Enter Global Configuration mode.
interface {vlan |
tunnel | loopback}
interface-id
Enter Interface Configuration mode for the specified VLAN,
tunnel, or loopback interface.
ipv6 address
{autoconfig | dhcp |
prefix/prefix-length
[eui64]}
Configure the IPv6 address and prefix length. Setting an
IPv6 address enables IPv6 on the interface. You can also use
the ipv6 enable command to enable IPv6 on the interface
without setting an address.
Link-local, multicast, IPv4-compatible, and IPv4-mapped
addresses are not allowed to be configured.
Include the eui64 keyword to have the system add the 64-bit
interface ID to the address. You must use a prefix length of
64 in this case.
For VLAN interfaces, use the dhcp keyword to enable the
DHCPv6 client and obtain an IP address form a network
DHCPv6 server or assign a static IP address.
ipv6 nd prefix
prefix/prefix-length
[{ valid-lifetime|
infinite} { preferred-
lifetime| infinite}]
[no-autoconfig] [off-
link]
Configure parameters associated with prefixes that the
router advertises in its router advertisements.
• ipv6-prefix—IPv6 prefix.
•
prefix-length—IPv6 prefix length.
• valid-lifetime—Valid lifetime of the router in seconds.
(Range: 0–4294967295 seconds.)
• infinite—Indicates lifetime value is infinite.
•
preferred-lifetime—Preferred-lifetime of the router in
seconds. (Range: 0–4294967295 seconds.)
• no-autoconfig—Do not use the prefix for
autoconfiguration.
• off-link—Do not use the prefix for onlink determination.