Dell POWEREDGE M1000E - Manual (Page 316)

316 Managing General System Settings
Managing the SDM Template
Beginning in Privileged EXEC mode, use the following commands to set the
SDM template preference and to view information about the available SDM
templates.
Configuring the Operational Mode and Port Aggregator Features
Beginning in Privileged EXEC mode, use the following commands to set the
operational mode to Simple and to configure the Port Aggregator features.
Command Purpose
configure Enter Global Configuration mode.
sdm prefer {dual-ipv4-
and-ipv6 default| ipv4-
routing {data-center |
default}}
Select the SDM template to apply to the switch after the
next boot.
CTRL + Z Exit to Privileged EXEC mode.
show sdm prefer
[ template]
View information about the SDM template the switch is
currently using. Use the template variable to view the
parameters for the specified template.
Command Purpose
configure Enter Global Configuration mode.
mode simple Enable Simple mode. Switching modes clears the running
configuration. You are prompted to confirm that you want
to continue.
NOTE: After the configuration clears, you are returned to
User EXEC mode if you are logged on through the console
port. If you are connected to the switch through Telnet or
SSH, the connection is terminated, and you must log on the
switch.
enable Enter Privileged EXEC mode.
configure Enter Global Configuration mode
port-aggregator group
{1–8}
Enter the Port Aggregator mode for the specified group to
configure aggregator group attributes.