Dell POWEREDGE M1000E - Manual (Page 1046)

1046 Configuring VRRP
Configuring VRRP Features (CLI)
This section provides information about the commands you use to configure
VRRP settings on the switch. For more information about the commands, see
the PowerConnect M6220/M6348/M8024/M8024-k CLI Reference Guide at
support.dell.com/manuals .
Configuring VRRP Settings
Beginning in Privileged EXEC mode, use the following commands to
configure switch and interface VRRP settings. This set of commands also
describes how to configure VRRP interface and route tracking.
Command Purpose
configure Enter global configuration mode.
ip vrrp Enable the administrative mode of VRRP for the router
(L3 switch).
interface vlan vlan-id Enter Interface Configuration mode for the specified
VLAN.
vrrp vr-id Allow the interface to create in the VRRP group specified
by the vr-id parameter, which is a number from 1–255.
vrrp vr-id description (Optional) Create a text description that identifies the
VRRP group.
vrrp vr-id preempt [delay
seconds]
Enable the preemption mode value for the virtual router
configured on a specified interface.
You can optionally configure a preempt delay, which is the
number of seconds the VRRP router waits before the
VRRP router sends an advertisement to claim master
ownership.
vrrp vr-id accept-mode Allow the VRRP Master to accept ping packets sent to one
of the virtual router’s IP addresses.
vrrp vr-id priority
priority
Set the priority value for the virtual router configured on
the interface.
vrrp vr-id ip ip-address
[secondary]
Set the virtual router IP address value for an interface.