Dell POWEREDGE M1000E - Manual (Page 912)

912 Configuring IP Routing
Adding Static ARP Entries and Configuring ARP Table Settings
Beginning in Privileged EXEC mode, use the following commands to
configure static ARP entries in the ARP cache and to specify the settings for
the ARP cache.
Command Purpose
configure Enter global configuration mode.
arp ip-address hardware-
address
Create a static ARP entry in the ARP table.
• ip-address — IP address of a device on a subnet attached
to an existing routing interface.
• hardware-address — A unicast MAC address for that
device.
arp timeout seconds Configure the ARP entry ageout time.
arp resptime seconds Configure the ARP request response timeout.
arp retries integer Configure the ARP count of maximum requests for
retries. The range is 1–10.
arp cachesize integer Configure the maximum number of entries in the ARP
cache.
arp dynamicrenew Allow the ARP component to automatically renew
dynamic ARP entries when they age out.
exit Exit to Privileged EXEC mode.
show arp [brief] View the entries in the ARP cache and the ARP table
settings. Use the brief keyword to view only the ARP table
settings.
clear arp-cache [gateway] Remove all dynamic ARP entries from the ARP cache.
Include the keyword gateway to remove gateway entries as
well.
clear arp-cache
management
Remove all dynamic ARP entries from the ARP cache that
were learned on the management interface.
arp purge ip-address Remove the specified IP address from the ARP cache.
This command removes dynamic and gateway ARP entries
only.