Configuring priority-based flow control, Pcm8024-k only) – Dell POWEREDGE M1000E User Manual

Page 707

Advertising
background image

Configuring Port-Based Traffic Control

707

Configuring Priority-Based Flow Control (PCM8024-k Only)

Beginning in Privileged EXEC mode, use the following commands to

configure PFC.

CTRL + Z

Exit to Privileged EXEC mode.

show interfaces detail

interface

Display detailed information about the specified interface,

including the flow control status.

show storm-control

View whether 802.3x flow control is enabled on the switch.

show storm-control

[

interface | all]

View storm control settings for all interfaces or the

specified interface.

Command

Purpose

configure

Enter global configuration mode.

interface

interface

Enter interface configuration mode for the specified

interface. The

interface variable includes the interface type

and number, for example gigabitethernet 1/0/3.
You can also specify a range of interfaces with the interface

range ethernet command, for example, interface range

gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,

and 12.

datacenter-bridging

Enter the Data Center Bridging mode. PFC commands are

issued from within this mode.

priority-flow-control

mode on

Enable PFC on the interface(s)

priority-flow-control

priority

priority-id {drop

| no-drop}

Use the no-drop option to enable the priority group for

lossless behavior. To enable lossy behavior, use the drop

form of the command.
priority-id — Specify the IEEE 802.1p priority value

(range: 0–7)

CTRL + Z

Exit to Privileged EXEC mode.

Command

Purpose

Advertising