Configuring mvr – Dell POWEREDGE M1000E User Manual

Page 761

Advertising
background image

Configuring L2 Multicast Features

761

Configuring MVR

Beginning in Privileged EXEC mode, use the following commands to

configure MVR features on the switch.

ipv6 mld snooping

querier election

participate

vlan-id

Allow the MLD snooping querier to participate in the

querier election process when it discovers the presence of

another querier in the VLAN. When this mode is enabled,

if the snooping querier finds that the other querier source

address is more than the snooping querier address, it stops

sending periodic queries. If the snooping querier wins the

election, then it continues sending periodic queries.

exit

Exit to Global Configuration mode.

ipv6 mld snooping

querier address

ipv6-

address

Specify the IP address that the snooping querier switch

should use as the source address when generating periodic

queries.

ipv6 mld snooping

querier query-interval

interval-count

Set the MLD snooping querier query interval time, which

is the amount of time in seconds that the switch waits

before sending another periodic query. The range is

1–1800 seconds.

ipv6 mld snooping

querier timer expiry

seconds

Set the MLD snooping querier timer expiration period.

This is the time period, in seconds, that the switch

remains in non-querier mode after it has discovered that

there is a multicast querier in the network.

exit

Exit to Privileged EXEC mode.

show ipv6 mld snooping

querier [detail |vlan

vlan-id]

View MLD snooping querier settings configured on the

switch, on all VLANs, or on the specified VLAN.

NOTE:

MVR is not supported on the PowerConnect M6220.

Command

Purpose

configure

Enter global configuration mode.

mvr

Enable MVR on the switch.

mvr vlan

vlan-id

Set the VLAN to use as the multicast VLAN for MVR.

Command

Purpose

Advertising