Crisp Solutions UC-515 - Manual (Page 35)

UCommand User’s Guide
Adjusting the LCD Backlight 29
4. VCR turns on
5. VCR starts playing tape
The macro button’s original function will not work unless you
delete the macro using the Delete button function. Refer to
Using the Delete Function on page 16.
Adjusting the LCD Backlight
You can adjust the length of time that the LCD backlight
stays on after you press the LCD panel, and it’s sensitivity
to ambient light. Refer to these instructions:
Press the AMP and
the AUX buttons at the
same time for three
seconds to enter the
backlight configuration
mode.
Note: Do not confuse
this button
combination with the
combination for
recalling the original
LCD layout (TV and
DVD).
You will hear a beep
and then you will see
the backlight adjust
mode enable screen
to the right.
Note: This screen
prevents you from
accidentally modifying
your UCommand.