Warning, Precaution, To remove the adaptor – Sony CCD-TR600 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
— For the customers supplied with the AC-V15 AC power adaptor
(1) Lift up the viewfinder.
(2) Connect the AC power cord to a wall outlet. Connect the coimecting plate to the battery mounting
surface of the camcorder.
(3) Set the selector to VTR (DC OUT).
2
3
N
w
0
1
V________________________________ _
4>M
||eO*«R| [n If^WPvrJ
___
J
WARNING
The power cord must only be changed at qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (mains) as long as it is connected to the wall
outlet, even if the set itself has been turned off.
Notes on the POWER lamp
• The POWER lamp will remain lit for a while even if the unit is unplugged after use. This is normal.
• If the POWER lamp does not light, set the selector to the center position (AC-V25A/V25B/V25C only)
and disconnect the power cord. After about one minute, reconnect the power cord and set the selector
to VTR (DC OUT) again.
To remove the adaptor
The adaptor is removed in the same way as the battery pack (p. 8).
o
3
See the next page for further iifformation.
19