To remove the battery pack, Installing the ba^ry pack – Sony CCD-TR600 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Charging and Installing the Battery Pack
To Remove the Battery Pack
Slide the battery pack in the direction of the arrow.
• The POWER lamp will remain lit for a while even if the battery pack is removed and the power cord
is unplugged after charging the battery pack. This is normal.
• If the POWER lamp does not light, set the selector to the center position (AC-V25A/V25B/V25C only)
and disconnect the power cord. After about one minute, reconnect the power cord and set the selector
to CHARGE again.
• You cannot operate the camcorder using the AC power adaptor while charging the battery pack.
installing the Ba^ry Pack
(1) Lift up the viewfinder.
(2) Align the right side of the battery pack with the white line on the camcorder, and slide the battery
pack to the right.
To Remove the Battery Pack
(1) Lift up the viewfinder.
(2) While pressing ВАТТ, slide the battery pack to the left.
8
^