Trouble check, Camcorder – Sony CCD-TR600 User Manual

Page 43

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Trouble Check

If you run into any problem using the camcorder, use the following table to troubleshoot the problem.
Should the difficulty persist, disconnect the power source and contact your Sony dealer or local
authorized Sony service facility.

Camcorder

Symptom

Cause

Corrective Actiorts

Page

im

«

s

£

The power is not on.

The battery pack is not
attached.

Attach the battery pack.

8

The battery is dead.

Use a charged battery pack.

6

The AC power adaptor
is not connected to a
wall outlet.

Connect the AC power adaptor to a
wall outlet.

18

The power goes off.

While being operated in
CAMERA mode, the
camcorder has been in
the Standby mode for
more than 5 minutes.

Turn STANDBY down once and
turn it up again.

11

The battery is dead.

Use a charged battery pack.

6

The battery pack is
quickly discharged.

The ambient
temperature is too low.

36

The battery pack has
not been charged fully.

Charge the battery pack again.

6

The battery pack is
completely dead, and
cannot be recharged.

Use another battery pack.

37

The beep sounds when
the battery is attached.

The battery is
discharged during a
long period of storage.

Charge the battery pack again.

6

C

. O

%

sii

START/STOP does not
operate.

The tape is stuck to the
drum.

Eject the tape.

9

The tape has run out.

Rewind the tape or use a new one.

16

The POWER switch is
set to VTR.

Set it to CAMERA.

10

The tab on the cassette
is out (red).

Use a new tape or slide the tab.

9

The cassette cannot be

removed from the
holder.

The battery is dead.

Use a charged battery pack or the
AC power adaptor.

6

18

No function except for
cassette ejection works.

Moisture condensation
has occurred.

Remove the cassette and leave the
camcorder for at least an hour.

39

The date or time
indicator is flashing.

You pressed DATE and
TIME together for more
than 2 seconds.

The camcorder is not
malfunctioning. You may start
recording. Flashing will stop soon.

The tape does not move
when a tape transport
button is pressed.

The POWER switch is
set to CAMERA or OFF.

Set it to VTR.

16

The tape has run out.

Rewind the tape or use a new one.

16

>

a

a

o

3

(to be continued)

43

Advertising