Using the remote 1 connector, Case, Notes – Sony PCM-R500 User Manual
Page 28: Additional information
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Additional Information
Remote Control Function Using
a Parallel Remote Connector
You can operate the deck with a parallel remote control
that uses a switch box connected to the REMOTE 1
connector on the rear panel.
Using the REMOTE 1 connector
When operating the deck with a parallel remote
control, set the REMOTE switch on the front panel to
WIRED.
The pin numbers and pin assignments for the
REMOTE 1 connector on the rear panel are as follows:
DIN connector (8 pin)
Case
Pin No
M0DE1
(playback)
M0DE2
(recording)
Inputs
1
H-level constant
L-level constant
2 ■
H-BTOP/L-PLAY
L-STOP
3
L-STOP
L-START ID
WRITE
4
L-PLAY
L-PLAY
5
L-REW
L-PAUSE
6
L-FF
L-REC
Status
7
H-STOP
H-REC-PAUSE
output
8
H-PLAY
H-REC
Case
GND
GND
Command inputs H: OPEN (off impedance: 30 kilohms or
more)
L: GND short (on impedance: 100 ohms
or less)
Status output H: approx 2V (I=15mA)
L: OPEN (High impedance)
Connection diagram (MODE 1)
1
2
3
4
5
6
7
8 Case
ci| c!)| (!)| (i| 1)|
OPEN
,GND
Notes
• When using MODE 2, use pin number 1 for GND.
• By keeping the input to pin number 1 constant at either H-
level or L-level determines whether pin numbers 2 to 8 are
in MODE 1 (playback) or MODE 2 (recording).
• In MODE 1, pin number 2 may be used for fader-start
function.
• For pin numbers 2 to 6 pin, input to smaller numbers take
priority.
• Anti-chattering measures should be taken for the
command input switches.
• Status output (pin numbers 7 and 8) is specially provided
for driving a single LED. If more current is needed, use an
additional drive circuit or electric power supply.
• Do not switch input to pin number 1 (MODE 1 and MODE
2) while the deck is playing or recording. This may result
in mis-operation of the deck.
Disabling Button Operations
(Key Protect Function)
(PCM-R700 Only)
You can disable certain button operations so that the
buttons do not work during, for instance, recording.
KEY PROTECT
AM of these buttons and dials
are disabled.
Set KEY PROTECT to ON.
Command input Status output
switch
display (LED)
2 8 ^