Contec SEH-9450-LAS - Manual (Page 19)

3. Hardware Installations
12
SEH-9450-LAS
CPU Installation:
This product supports a single Intel socket-M type Core Duo processor or Core 2 Duo processor. The
processor’s VID pins automatically program the voltage regulator on the CPU card to the required
processor voltage. The host bus speed is automatically selected. The processor connects to the CPU
card through the socket M.
The socket-M comes with a turn lock to secure the processor. Make sure the notch on the corner of the
CPU corresponds with the notch on the inside of the socket.
After you have installed the processor into the socket-M, check if the configuration setup for the CPU
type and speed are correct. The CPU should always have a Heat Sink and a cooling fan attached to
prevent overheating.
Refer to the description of optional heat sink fan appending for attachment of a heat sink fan.
Main Memory Installation: DIMM1, DIMM2
The product supports one single-side or double-sided DDR2-667 unregistered SO-DIMM, 200-pin
sockets for a maximum total memory of 2GB.
This product supports the following memory features:
- 200-pin SO-DIMM with gold-plated contacts
- 400 / 533 / 667 Mhz DDR2 SDRam
- 1.8V memory only.
- Single or double-sided SO-DIMM in the following sizes:
NOTE : Install 4GB Memory Only recognize 3.1GB
Table 3.1. DDR2 SDRAM
SO-DIMM Capacity Non-ECC configuration
256MB 32M x 16
512MB 32M x 16
512MB 64M x 8
1GB 64M x 8
1GB 128M x 8
2GB 128M x 8
CAUTION
All memory components and SO-DIMM used with the SEH-9450-LAS CPU card must comply with
the PC SDRAM Specification. These include: the PC SDRAM Specification (memory component
specific), the PC Un-buffered DIMM Specification, and the PC Serial Presence Detect Specification.