Attaching the control unit to the camera – Canon MR-14EX User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching the Control Unit to the Camera
1
Loosen the locking collar by
turning it as shown by the arrow.
Slip the Control Unit’s mounting
foot into the camera’s hot shoe aii
the way.
3
Turn the iocking collar as shown
by the arrow and tighten.
► The mounting foot’s locking pin will
also extend into the hot shoe.
•To detach the Control Unit, turn the
locking collar in the opposite direction
until it stops. (The locking pin retracts
into the mounting foot.) Then slip it
off the hot shoe.
O The hot shoe on the EOS 650, 620, 750i and 850 does not have a locking pin
hole. Although the MR-14EX can still be mounted on these cameras, be careful
not to have it slip off the hot shoe.
13