Press the <ratio> button and select a : b, Focus and take the picture, Firing both flash tubes – Canon MR-14EX User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Selecting the Flash Tube
Firing Both Flash Tubes
Press the <RATIO> button and
select
a
:
b
.
►
Each time you press the button, the
selection will change in the following
loop:
I—^(OFF)—► GESiB] A : B —I
I---- ^A : B c^---------------------- 1
►
The flash ratio and the and di:-
icons will be displayed.
Press the <
O
> or <
O
> button to
move the bar
h
left or right to set
the respective A:B flash ratio.
• You can set the flash ratio from 1:8 to
1:1 to 8:1
I
Focus and take the picture.
• Check that the J icon (flash ready) is
displayed in the viewfinder before
taking the picture.
0 • The flash ratio for the short bars
8:1
•
4:1
•
2:1
•
1:1
•
I on the flash ratio scale Is as shown below.
1:2
-
1:4
-
1:8
(5.6:1) (2.8:1) (1.4:1) (1:1.4) (1:2.8) (1:5.6)
• In exposure stops, the flash ratio range is equivalent to 3:1 to 1:1 to 1:3.
• Even if the
icon is not displayed, both flash tubes will fire. The flash
output will be the same for both flash tubes.
• You can also use the < SEUSET > button and < + ><—•> buttons to set the
flash ratio for flash tubes A and B.
27