AVer CMS User Manual
Page 85
Advertising
78
3.
Using the screwdriver to lose the pin hole of RS485 to RS232 converter. And then, insert
another side of single core wire into the pin hole of the RS485 to RS232 converter. Using the
screwdriver to screw tight the wire. Please refer to the below table for pin-hole matching:
RS485 pin hole of System Controller
RS485 to RS232 Converter site
System Controller site
R+
T+
1
R-
T-
2
T+
R+
3
T-
R-
4
4.
Connect the RS232 cable to the RS232 port of the converter.
5.
Connect another side of RS232 cable to the RS232 port of the CMS server.
6.
Power on the System Controller.
7.
The following figure is an example of the installation illustrate.
Advertising