CDI Torque MULTITEST Motorized Loader - Manual (Page 11)

III
Safety Information
WARNING
• Make sure all components, including, adaptors,
extensions, drivers and sockets are rated to
match or exceed the torque or load being applied.
• Be sure the capacity of the Motorized Control
Loader System matches or exceeds each
application before performing a procedure.
• Do not use the Mototrized Control Loader System
if it makes unusual noises, has loose parts, or
shows any other sign of damage. Have repairs
performed at an Authorized Service Center before
use.
• Do not use chipped, cracked, or damaged sockets
and accessories.
• Do not remove any labels. Replace any damaged
label.
• Follow good, professional tool practices:
— Pull on a wrench handle—do not push—and
adjust stance to prevent a possible fall.
— Do not use extensions, such as a pipe, on a
wrench handle.
• When using ratchets, make sure the direction
lever is fully engaged in the correct position.
• Never attempt to test an impact tool on this
instrument.
• Always position the 40" arm over the front of the
stand as shown. Never extend the test arm
behind the stand. The stand will tip over when
weights are applied.
• Always be alert to the potential for personal injury
that may be caused by excessive torque
applications, careless handling of heavy weights,
and out-of-balance or unsafe weight distribution.