CDI Torque MULTITEST Motorized Loader - Manual (Page 50)

4-6
Using the Multitest Toque Calbration System
3. Press MODE to select TRACK mode. The green TRACK
lamp lights.
4. Adjust the power tool to the desired torque output, if
possible.
5. Adjust the appropriate joint rate simulator assembly for
the desired soft-hard configuration.
6. Install the joint rate simulator onto the MULTITEST
transducer, as shown in Figure 4-1. Secure the
transducer set screw, if provided. Loosen the simulator
load screw using the appropriate hex or box wrench.
Figure 4-1: Power Tool Test Setup
A – Power Tool
B – Joint Rate Simulator
C – Transducer
7. Couple the power tool to the joint rate simulator using
the appropriate accessory adaptor and bit.
8. While holding the power tool drive perfectly in-line with
the transducer drive, energize the tool until its motor
stalls or, if featured, the tool clutch slips.
9. Remove the power tool. Loosen the joint rate simulator
load screw.
10. Repeat steps 7 through 9 twice again to exercise the
tool-simulator assembly and the MULTITEST transducer.
11. Remove the power tool from the loader-transducer and
press ZERO TARE.
12. Press MODE to select POWER TOOL mode. The yellow
POWER TOOL lamp lights.