CDI Torque MULTITEST Motorized Loader - Manual (Page 3)

Toggles between TORQUE and FORCE
measurement modes.
Selects TRACK, PEAK HOLD, POWER
TOOL, FIRST PEAK and ANGLE modes.
Selects following units on LCD display:
Torque units in: Nm, dNm, cNm, mkg,
cmkg, lb ft, in lb, in oz, or
Force units in: N, dN, kp, gf,lbf, oz.
Manually resets ANGLE display on LCD.
Manually resets ZERO TARE.
Selects LED or LCD digit to right (blinking)
for setup and programming. Shift for
printer and angle encoder programming.
Selects LED or LCD digit to left (blinking)
for setup and programming. Shift for
printer and angle encoder programming.
Terminates calibration and program
modes. Returns to 4-in-1 transducer scan.
Increments selected digit during calibration
and program modes. Scrolls statistical
analysis display.
Decrements selected digit during
calibration and program modes. Scrolls
statistical analysis display.
Opens and terminates calibration mode.
Edits DATE/TIME programming function.
Sets up high torque/force limit preset. Set
up angle preset in torque-angle mode.
Sets up low torque/force limit preset. Set
up clamping torque preset in torque-angle
mode.
Stores present measurement to memory.
Recalls memory data to display.
Sends all memory data, statistical analysis
and histogram to printer/port.
Sends data list with or without date-time
stamp to computer printer. Sets up serial
protocol function.
Sets up CLEAR, STORE, and SEND
modes function.
Manually clears display in PEAK, FIRST
PEAK, POWER TOOL and ANGLE modes.
Sets up memory clear options in RECALL
mode.
Front Panel Function Keys