BoonDocker ARCTIC CAT: M1000 Race Gas - Manual (Page 12)

Revised 11/18/08 Arctic Cat M-1000 Turbo Installation instructions Page 12
www.boondockers.com............................
BoonDocker
..........................................877-522-7805
I. Install the 5 hole muffler flange to the turbo exhaust housing using the 5- 8mm
x25mm Allen heat bolts. Install the 4 gold springs as shown.
Step: 7 Fuel System
Parts Needed: Tools Needed:
Fuel regulator fitting (Copper) Basic tool set
1/8” NPT x 1/8” PTC 90 Vise
1/4 “ flat washer Drill w/ 5/16” drill bit
Bulkhead fitting with 1/8” push to connect Nut driver
5/16 nylon lock nut
4- 8” cable zip ties
Note: The 2008 and older sleds will need a
replacement pump provided by Boondocker.
A. Disconnect and remove the electrical connector for
fuel pump, fuel line, brass fitting and the nut shown
in picture, then remove the factory fuel pump from
the gas tank.