Dynojet 224/4WD: Installation Guide - Manual (Page 11)

In Ground Model 224 4WD Automotive Dynamometer Installation Guide
1-1
C
H A P T E R
1
S
PECIFICATIONS AND
O
PERATING
R
EQUIREMENTS
Thank you for purchasing Dynojet’s In Ground Model 224 Automotive Dynamometer
(dyno) with Four Wheel Drive (4WD) Attachment. Dynojet’s software and
dynamometers will give you the power to get the maximum performance out of
vehicles you evaluate. Whether you are new to the benefits of a chassis dynamometer
or an experienced performance leader, the repeatability and diagnostic tools of
WinPEP 7 software and a Dynojet dynamometer will give you the professional results
you are looking for.
This document provides instructions for installing the 224 4WD dyno. This document
will walk you through operating requirements, hardware installation, electronics set
up, and basic dyno operation. To ensure safety and accuracy in the procedures,
perform the procedures as they are described.
Document Part Number: 98210104
Version 3
Last Updated: 08-15-05
This chapter is divided into the following categories:
• Introduction, page 1-2
• Dynamometer Specifications and Requirements, page 1-4
• Model 224 4WD Pit Dynamometer, page 1-8
• Model 224 4WD Pit Dynamometer with Grates, page 1-9
• Pit Specifications, page 1-10