Dynojet 224/4WD: Installation Guide User Manual
Page 26
Advertising
In Ground Model 224 4WD Automotive Dynamometer Installation Guide
C H A P T E R 2
Track Assembly
2-6
4
Loosely install the ten rail tie clips using one bolt, one lock washer, and one flat
washer per clip. There are five rail tie clips on each side of the track assembly.
5
Verify the track assembly is square and make any necessary adjustments.
6
Tighten all ten bolts.
Note: For clarity, the pit is not shown.
Figure 2-4: Install the Rail Tie Clips
lock washer
bolt
flat washer
rail tie clip
rail
anchor in
pit floor
rail tie
Advertising