Dynojet 224/4WD: Installation Guide - Manual (Page 68)

In Ground Model 224 4WD Automotive Dynamometer Installation Guide
C H A P T E R 4
Preventative Maintenance
4-14
3b Pull the slave cylinder away from the dyno being careful not to kink the
brake line.
3c Screw the brake piston rod in to increase brake shoe clearance or out to
decrease brake shoe clearance.
3d Attach the slave cylinder using the bolts and washers removed earlier.
3e Recheck brake shoe clearance. No part of the brake shoe should touch the
drum!
4 If you cannot adjust the brakes to specification, you will need new brake shoes.
Contact Dynojet.
Turn on or reconnect the air supply and check that the drum brakes operate
before replacing the covers and using the dyno.
Figure 4-8: Pull Cylinder Away
brake slave cylinder
brake piston rod
brake shoe