Dynojet 224/4WD: Installation Guide - Manual (Page 23)

I N S T A L L A T I O N
Track Assembly
Version 3 In Ground Model 224 4WD Automotive Dynamometer Installation Guide
2-3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TRACK ASSEMBLY
The following instructions are the same when using both 224 and 248 stationary
dynos. We will use the model 224 pit dyno as the stationary dyno for the following
steps.
Note: The stationary dyno must be installed before proceeding with the 4WD
dyno installation. Depending on the model dyno, refer to the following manuals:
Before installing the track assembly, layout the entire track assembly in the pit using
the following instructions for position and alignment.
1
Line up the center line of the track assembly with the center line of the stationary
224 dyno.
2 Measure the following distances and set the track assembly in the pit as listed
below and shown in Figure 2-2.
• The track assembly should be 4.50 cm (1.75 in.) from the pit wall.
• The distance between the inside of the rails should be 184.15 cm
(72.50-inches +/- 0.06 in.).
• The distance from the first rail tie assembly to the first rail tie should be
44.77 cm (17.625 in.).
• The distance from the first rail tie assembly to the second rail tie is 94.30 cm
(37.125 in.).
• The distance from the first rail tie assembly to the third rail tie is 143.83 cm
(56.625 in.).
3 Verify the track assembly is square by measuring from corner to corner.
4 Mark and drill all ten holes, five on each side of the track assembly.
5 Set the track assembly aside.
6 Install the Red Head anchors. Refer to Appendix A for installation instructions.
part number manual
98210100 Installation Guide for Model 224 Pit Automotive
Dynamometers
98219100 Installation Guide for Model 248 Pit Automotive
Dynamometers