Placing the dyno in the pit, Placing the dyno in the pit -9 – Dynojet 224/4WD: Installation Guide User Manual
Page 29
I N S T A L L A T I O N
Dyno Installation
Version 3
In Ground Model 224 4WD Automotive Dynamometer Installation Guide
2-9
P
LACING
THE
D
YNO
IN
THE
P
IT
You will need to keep the cable track routed underneath the dyno and towards the
stationary dyno.
1
Verify the rail clamps are positioned as shown in Figure 2-7.
2
Verify the dyno movement motor is facing away from the stationary dyno.
3
Using the forklift, gently lower the dyno onto the rails.
Note: Make sure the dyno movement motor is facing away from the stationary
dyno.
Note: For clarity, the pit in Figure 2-7 has been cut away to show the rail clamp
positions.
Figure 2-7: Lower the Dyno into Pit
rail clamp
dyno movement motor facing
away from stationary dyno
cable track under dyno and
towards stationary dyno