Dynojet 224/4WD: Installation Guide - Manual (Page 66)

In Ground Model 224 4WD Automotive Dynamometer Installation Guide
C H A P T E R 4
Preventative Maintenance
4-12
M ODEL 224 D YNOS WITH 4WD A TTACHMENT —T HINGS TO C HECK
• Check the air motor lubricator once per month, fill as necessary. Disconnect the air
before removing the lubricator bowl.
• Shut off or disconnect the air supply to the dyno, and follow lock out
procedure.
• Press and hold the dyno in or out movement switch until you cannot hear any
air going through the movement motor.
Before running the Gast Air Motor, remove the lubricator bowl and fill the bowl
with oil.
Note: Use a non-detergent SAE #10 automotive engine oil (Gast Part #AD220).
Figure 4-6: Check Air Motor Lubricator
• Check customer supplied air filter/dryer daily, empty and clean as necessary.
• Inspect the 4WD dyno movement rails for debris once per month. Clear any debris
from the rails.
remove bowl and
fill to line with oil