Dynojet 224/4WD: Installation Guide - Manual (Page 46)

In Ground Model 224 4WD Automotive Dynamometer Installation Guide
C H A P T E R 2
Grate Placement and Installation
2-26
I NSTALLING THE C ENTER G RATES AND C ENTER P LATE
1 Place the center grates on the dyno so the long lip faces the drum.
2 Loosely secure each grate to the dyno using two 3/8 x 3-inch button-head bolts.
3 Loosely secure the center plate to the grates using ten 3/8 x 1-inch button-head
bolts.
4 Loosely secure the center plate to the dyno using one 3/8 x 3-inch button-head
bolt.
5 Verify the center plate and grates are aligned with the dyno and tighten all the
bolts.
Figure 2-23: Installing the Center Grates and Center Plate
long lip on
center grate
center plate
center plate