Installing the cross brace assemblies, Installing the cross brace assemblies -24 – Dynojet 224/4WD: Installation Guide User Manual
Page 44
Advertising
In Ground Model 224 4WD Automotive Dynamometer Installation Guide
C H A P T E R 2
Grate Placement and Installation
2-24
I
NSTALLING
THE
C
ROSS
B
RACE
A
SSEMBLIES
Each cross brace assembly has two halves that must be assembled together before
installing the cross brace assemblies in the pit.
1
Loosely connect the two halves of each cross brace using three 3/8-inch bolts.
2
Slide the brace halves apart until the assembly is the same width as the pit.
3
Tighten the bolts.
Figure 2-21: Connecting the Cross Brace Halves
width of pit
Advertising