EFCO 945 Series - Manual (Page 49)

2 1/4"
SECTION X - DOOR FRAMES
STEP 1) DOOR STOP CUT LENGTH AND INSTALLATION
DOOR STOP
Install the applied door stop into position on the door frame by spacing it off the exterior face of
the door frame at the appropriate dimension, depending on door thickness. Using STT6
fasteners, 3" from each end and 12" O.C., fasten the door stop to the door jamb and door header.
After determining that the door stop is in the correct position, apply the door stop cover by
snapping it into the door stop raceway. See Figure 69.
APPLIED
DOOR STOP
(9154/9155)
[FIG. 69]
2
1/4"
APPLIED DOOR
STOP (9154/9155)
VARIES
VA
R
IE
S
PAGE 47
STANDARD
DOOR HEADER
(8303)
STANDARD
DOOR JAMB
(8311)
HORIZONTAL CUT LENGTH = DOOR OPENING WIDTH
VERTICAL CUT LENGTH =
[DOOR OPENING HEIGHT - HORIZONTAL DOOR STOP HEIGHT]
1/4" Dia. WEEP
at 1/4 POINTS
9
/16"
MDM
01/2007