Jeep 2015 Cherokee - Owner Manual - Manual (Page 43)

NOTE: The vehicle will only unlock the doors when a
valid Passive Entry RKE transmitter is detected inside the
vehicle, and no valid Passive Entry RKE transmitter is
detected outside the vehicle. The vehicle will not unlock
the doors when any of the following conditions are true:
• The doors are manually locked using the door lock
knobs.
• There is a valid Passive Entry RKE transmitter outside
the vehicle and within 5 ft (1.5 m) of either Passive
Entry door handle.
• Three attempts are made to lock the doors using the
door panel switch and then close the doors.
To Unlock/Enter The Liftgate
The liftgate passive entry unlock feature is built into the
electronic liftgate release. With a valid Passive Entry RKE
transmitter within 3 ft (1.0 m) of the liftgate, push the
electronic liftgate release to open with one fluid motion.
NOTE: If “Unlock All Doors 1st Push” is programmed in
EVIC/DID (if equipped), all doors will unlock when you
push the electronic release on the liftgate. If ЉUnlock
Driver Door 1st PushЉ is programmed in Uconnect®, the
liftgate will unlock when you push the electronic release
on the liftgate. For further information, refer to
“Uconnect®” in “Understanding Your Instrument
Panel.”
To Lock The Liftgate
With a valid Passive Entry RKE transmitter within 3 ft
(1.0 m) of the liftgate, push the passive entry lock button
located to the right of electronic liftgate release.
NOTE:
The liftgate passive entry lock button will lock all
doors and the liftgate. The liftgate unlock feature is built
into the electronic liftgate release.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 41