Kontron AT8404 - Manual (Page 26)

Installation
13 AT8404 User Guide
www.kontron.com
2.2 AT8404 Initial Installation Procedures
The following procedures are applicable only for the initial installation of the AT8404 in a system. Proce-
dures for standard removal and hot swap operations are found in their respective chapters.
To perform an initial installation of the AT8404 in a system proceed as follows:
1. Ensure that the safety requirements indicated in section 2.1. are observed.
2. Ensure that the board is properly configured for operation in accordance with application requirements
before installing. For information regarding the configuration of the AT8404 refer to Chapter 4.
3. To install the AT8404 perform the following:
1. Carefully insert the board into the slot designated by the application requirements for the board un-
til it makes contact with the backplane connectors.
2. Using the ejector handle, engage the board with the backplane. When the ejector handle is locked,
the board is engaged.
3. Fasten the front panel retaining screws.
4. Connect all external interfacing cables to the board as required.
5. Ensure that the board and all required interfacing cables are properly secured.
4. The AT8404 is now ready for operation.
WARNING
Failure to comply with the instruction below may cause damage to the
board or result in improper system operation.
WARNING
Care must be taken when applying the procedures below to ensure that
neither the AT8404 nor other system boards are physically damaged by
the application of these procedures.
WARNING
DO NOT push the board into the backplane connectors. Use the ejector
handles to seat the board into the backplane connectors.