Kontron KTGM45-mITX - Manual (Page 94)

KTGM45 Users Guide
KTD-N0793-O Page 94
7.7.1 Advanced Chipset Settings – North Bridge Chipset Configuration
BIOS SETUP UTILITY
Chipset
North Bridge Chipset Configuration ENABLE: Allow remapping
of overlapped PCI memory
above the total physical
memory.
Disable: Do not allow
remapping of memory
<-> Select Screen
|| Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
Thermal Memory Reference Code(TMRC)
TS on DIMM [Disabled]
Memory Hole [Disabled]
Boots Graphic Adaptor Priority [PEG/PCI]
Internal Graphics Mode Select [Enabled,32MB]
Gfx Low Power Mode [Enabled]
PEG Port Configuration
PEG Port [Auto]
Force X1 Link Width [Disabled]
► Video Function Configuration
v02.67+ (C)Copyright 1985-2009, American Megatrends, Inc.
Feature Options Description
TS on DIMM Disabled
Enabled
Enable/Disable Thermal Sensor on DIMM.
Memory Hole Disabled
15MB-16MB
Disabled
15MB-16MB
Boots Graphic Adaptor Priority IGD
PCI/IGD
PCI/PEG
PEG/IGD
PEG/PCI
Select which graphics controller to use as the
primary boot device.
Internal Graphics Mode Select Disabled
Enabled, 32MB
Enabled, 64MB
Enabled, 128MB
Select the amount of system memory used by the
Integrated Graphic Device.
Gfx Low Power Mode Disabled
Enabled
This option is applicable for SFF only.
Force X1 Link Width Disabled
Enabled
Enabled: Force PCIe x16 to work as PCIe x1
PEG Port Auto
Disabled
Enable PEG Always
Auto
Disabled
Enable PEG Always
Notes: Memory Remap Feature should be Enabled when using 64bit OS and has effect if using more than
4GB of memory. If using 32bit OS and more than 3GB (max 4GB) then up to ½ GB might be lost if Memory
Remap Feature is Enabled, so in general it is recommended to Disable the Memory Remap Feature when 32
bit OS is used.
Using PCIe Graphics card in combination with on-board graphics (VGA or LVDS) is possible if BIOS (from
version KTGM4506) setting Boots Graphic Adaptor Priority = IGD. In this case on-board graphic will be
Primary desktop and PCIe Graphics will be extended desktop. Note that PCIe Graphics driver shall be
installed before the Intel Graphics driver.
BIOS setup