Driving and parking, Driving systems – Mercedes-Benz C-Sedan 2014 Owners Manual User Manual
Page 203
In addition, a lane with lane markings on both
sides must be recognized. The brake
application also slightly reduces vehicle
speed.
If a lane-correcting brake application occurs,
the following, for example, appears in the
multifunction display:
i
A further lane-correcting brake
application can only occur after your
vehicle has returned to the original lane.
No lane-correcting brake application occurs
if:
R
you clearly and actively steer, brake or
accelerate.
R
you cut the corner on a sharp bend.
R
you switch on the turn signals.
R
a driving safety system intervenes, e.g.
ESP
®
, PRE-SAFE
®
Brake or Active Blind
Spot Assist.
R
you have adopted a sporty driving style with
high cornering speeds or high rates of
acceleration.
R
ESP
®
is switched off.
R
the transmission is not in position D.
R
a loss of tire pressure or a defective tire has
been detected and displayed.
Active Lane Keeping Assist does not detect
traffic situations or road users. An
inappropriate brake application may be
interrupted at any time if you:
R
steer slightly in the opposite direction
R
use a turn signal
R
clearly brake or accelerate
A lane-correcting brake application is
interrupted automatically if:
R
a driving safety system intervenes, e.g.
ESP
®
, PRE-SAFE
®
Brake or Active Blind
Spot Assist.
R
lane markings can no longer be recognized.
Switching on Active Lane Keeping Assist
X
Switch on Active Lane Keeping Assist using
the on-board computer; to do so, select
Standard
or
Adaptive
(
Y
page 214).
If you drive at speeds above 40 mph
(60 km/h) and lane markings are detected,
the lines in the assistance graphics display
(
Y
page 213) are shown in green. Lane
Keeping Assist is ready for use.
If
Standard
is selected, no warning
vibration occurs if:
R
you have switched on the turn signals. In
this event, the warnings are suppressed
for a certain period of time.
R
a driving safety system intervenes, such
as ABS, BAS or ESP
®
.
When
Adaptive
is selected, no warning
vibration occurs if:
R
you have switched on the turn signals. In
this event, the warnings are suppressed
for a certain period of time.
R
a driving safety system intervenes, e.g.
ABS, BAS or ESP
®
.
R
you accelerate hard, e.g. kickdown.
R
you brake hard.
R
you steer actively, e.g. swerve to avoid
an obstacle or change lanes quickly.
R
you cut the corner on a sharp bend.
Driving systems
201
Driving
and
parking
Z