Breakdown assistance, Towing and tow-starting – Mercedes-Benz C-Sedan 2014 Owners Manual User Manual

Page 311

Advertising
background image

Installing/removing the towing eye

Installing the towing eye

G

WARNING

The exhaust tail pipe may be very hot. There

is a risk of burns when removing the rear

cover.
Do not touch the exhaust pipe. Take particular

care when removing the rear cover.

X

Remove the towing eye from the vehicle

tool kit (

Y

page 300).

The mountings for the removable towing eyes

are located in the bumpers. They are at the

front and at the rear, behind the covers.

X

Press the mark on cover : inwards in the

direction of the arrow.

X

Take cover : off the opening.

X

Screw in and tighten the towing eye

clockwise to the stop.

Removing the towing eye

X

Unscrew and remove the towing eye.

X

Attach cover : to the bumper and press

until it engages.

X

Place the towing eye in the vehicle tool kit.

Towing the vehicle with the rear axle

raised

Only possible for vehicles without

4MATIC.
When towing your vehicle with the rear axle

raised, it is important that you observe the

safety instructions (

Y

page 308).

!

The ignition must be switched off if you

are towing the vehicle with the rear axle

raised. Intervention by ESP

®

could

otherwise damage the brake system.

X

Switch on the hazard warning lamps

(

Y

page 117).

X

Turn the SmartKey to position 0 in the

ignition lock and remove the SmartKey

from the ignition lock.

X

When leaving the vehicle, take the

SmartKey or the KEYLESS-GO key with you.

Towing a vehicle with both axles on

the ground

It is important that you observe the safety

instructions when towing away your vehicle

(

Y

page 308).

X

Switch on the hazard warning lamps

(

Y

page 117).

i

When towing with the hazard warning

lamps switched on, use the combination

switch as usual to signal a change of

direction. In this case, only the indicator

lamps for the direction of travel flash. After

resetting the combination switch, the

hazard warning lamp starts flashing again.

X

Turn the SmartKey to position 2 in the

ignition lock.

X

When the vehicle is stationary, depress the

brake pedal and keep it depressed.

X

Shift the automatic transmission to

position N.

X

Release the brake pedal.

X

Release the parking brake.

Towing and tow-starting

309

Breakdown

assistance

Z

Advertising