Last destinations, Comand, Navigation – Mercedes-Benz S-Class 2011 User Manual
Page 180
will appear asking whether you wish to
overwrite the existing data.
X
Select
Yes
or
No
and press W to confirm.
If you select
Yes
, COMAND stores the data.
Deleting a destination or the home
address from the destination memory
X
To switch on navigation mode: press the
S function button once or twice.
X
To show the menu: press W the COMAND
controller.
X
Select
Destination
in the navigation
menu bar by turning cVd the COMAND
controller and press W to confirm.
X
Select
From Memory
and press W to
confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
X
Option 1 – destination memory list with
character bar: proceed as described in the
"Entering characters using the character
bar" section (
X
Option 2 - destination memory list as a
selection list: select the destination by
turning cVd the COMAND controller and
press W to confirm.
The address data appears for the selected
entry.
X
Select
Delete
and press W to confirm.
A prompt appears asking whether you wish
to delete the destination.
X
Select
Yes
or
No
and press W to confirm.
If you select
Yes
, COMAND deletes the
destination. You see a message to this
effect.
If you select
No
, the process will be
canceled.
i
If the navigable address data for the
destination being deleted is also assigned
to an address book entry, COMAND will
also delete this data from there. If the
corresponding address book entry does
not contain any further data, such as
telephone numbers, COMAND deletes the
entire address book entry.
Last destinations
Introduction
COMAND automatically stores the previous
destinations for which the route calculation
was started. If the memory is full, COMAND
deletes the oldest destination. You can also
store one destination from the list of previous
destinations in the destination memory. It will
be stored there permanently.
Storing a destination permanently in
the destination memory
X
Proceed as described in the "From the list
of previous destinations" section
(
Storing the vehicle position in the list of
previous destinations
X
To switch on navigation mode: press the
S function button once or twice.
X
To show the menu: press W the COMAND
controller.
X
Select
Position
in the navigation menu
bar by turning cVd the COMAND
controller and press W to confirm.
X
Select
Store Vehicle Position
and
press W to confirm.
COMAND stores the current vehicle
position as a destination in the list of
previous destinations.
178
Navigation
COMAND