Mercedes-Benz S-Class 2011 - Manual (Page 185)

Road display
Road display active
:
Street name or street number, e.g. for
highways
Geo-coordinate display
Geo-coordinate display active
:
Current height above sea level, rounded
up
; Current vehicle position: latitude
coordinates
=
Current vehicle position: longitude
coordinates
? Number of GPS satellites currently being
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be grayed out. Height
display : may vary from the actual value,
because the navigation system uses the GPS
signal for the calculation.
When scrolling the map (
Y page 158), you will
see the geo-coordinates of the crosshair
positions, but height display : and number
of satellites used ? are not displayed.
"None" menu option
Display switched off
:
Currently set map orientation
i During the "Move map" function, you can
see additional data depending on the
position of the crosshair, such as a road
name, if the digital map supports this data.
Activating/deactivating the
topographical map
The topographical map shows different
heights using different colored height levels.
Generally, a color scale in which the colors
correspond to the natural coverage or colors
as seen from the air is used, e.g.:
R green for flat land
R
yellow and brown for hills
R
gray and white for mountains
X To show the menu: press the COMAND
controller W.
X Select Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X Select Topographical Map and press W
to confirm.
Depending on the previous state, switch
the option on O or off ª.
Switching the city model on/off
When the city model is switched on, the map
shows buildings in 3D.
i The city model is only shown in the "3D
map" map orientation.
It is available in the 50 m and 100 m map
scales.
Navigation
183
COMAND
Z