Mercedes-Benz S-Class 2011 - Manual (Page 94)

X Touch sensor surface : on the door
handle until the side windows and the
sliding sunroof or the panorama roof with
power tilt/sliding panel are fully closed.
i Make sure you only touch sensor
surface :.
X Make sure that all the side windows and the
sliding sunroof or panorama roof with
power tilt/sliding panel are closed.
X To interrupt convenience closing:
release sensor surface : on the door
handle.
On vehicles with roller sunblinds:
X Touch the sensor surface on the door
handle again until the roller sunblinds
close.
X To interrupt the roller sunblind closing
procedure: pull the outside door handle
and hold firmly.
Resetting the side windows
You must reset each side window if:
R
a side window cannot be closed
automatically.
R a side window opens again slightly after
being closed manually.
X Close all the doors.
X Turn the SmartKey to position 1 in the
ignition lock.
X Pull the corresponding switch on the door
control panel until the side window is
completely closed. (
Y page 90)
X Hold the switch for an additional second.
If the side window opens again slightly:
X Immediately pull the corresponding switch
on the door control panel until the side
window is completely closed (
Y page 90).
X Hold the switch for an additional second.
X If the corresponding side window remains
closed after the button has been released,
the side window has been reset correctly.
If this is not the case, repeat the steps
above again.
Problems with the side windows
Problem: a side window cannot be closed
because objects are trapped between the
side window and the door frame.
X Remove the objects.
X Close the side window.
Problem: a side window cannot be closed
because objects in the guide rail are
preventing the window from being raised.
X Remove the objects.
X Close the side window.
Problem: a side window cannot be closed,
and you cannot see the cause.
G Warning
Closing the side windows with increased force
or without the anti-entrapment feature could
lead to serious or even fatal injury. Make sure
that nobody can become trapped when
closing the side windows.
If a side window is obstructed during closing
and reopens again slightly:
X Immediately after the window blocks, pull
the corresponding switch again until the
side window has closed.
The side window is closed with increased
force.
If a side window is obstructed again during
closing and reopens again slightly:
X Immediately after the window blocks, pull
the corresponding switch again until the
side window has closed.
The side window is closed without the anti-
entrapment feature.
G Warning!
Pulling and holding the switch to close the
door window immediately after it had been
blocked two times will cause the door window
92
Side windows
Opening and closing