Mercedes-Benz S-Class 2011 - Manual (Page 189)

is supplied on a DVD (all other countries). You
do not need an activation code for the map
software that is delivered with your vehicle.
You also do not need to enter an activation
code if map software has already been
installed in the vehicle and must be installed
again.
Installation process
X Load the map software DVD in the DVD
drive (
Y page 217).
COMAND checks the DVD and shows a
corresponding message in the display.
The map software is not compatible with
the navigation system
A message appears informing you that it is
not possible to install the map software.
X To confirm the message: press W.
COMAND ejects the DVD.
X Take the DVD out of the slot.
X Load a DVD that is compatible with the
vehicle's navigation system.
The map software is not compatible with
the current system software
A message appears informing you that the
system software and the map software are
not compatible.
X To confirm the message: press W.
COMAND ejects the DVD.
X Take the DVD out of the slot.
X Have the system software updated at an
authorized Mercedes-Benz Center.
It is only possible to install the map software
after the system software has been updated.
The map software is compatible with the
navigation system and the current
system software
COMAND checks whether the DVD map data
has already been installed.
The map data has already been installed
A message appears informing you that the
map data has already been installed, and a
prompt asks you whether the map software
should be installed anyway.
X Select Yes or No .
If you select Yes , the existing map data is
overwritten.
If you select
No , COMAND ejects the DVD
automatically and the installation of the
map software is canceled.
X Take the DVD out of the slot.
Map data is not yet installed
The version data of the map software DVD
and the map software installed on COMAND
are shown in the display for comparison. A
prompt then appears, asking whether the
map software should be installed.
X Select Yes or No .
If you select Yes , the map data is saved.
If you select No , COMAND ejects the DVD
automatically and the installation of the
map software is not continued.
X Take the DVD out of the slot.
If an activation code is required for the map
software, a prompt appears in the display
asking you to enter it.
X Enter the activation code and press ! to
confirm.
The software is installed.
If you enter an incorrect activation code, a
prompt appears asking you to enter the
activation code again. After the activation
code has been entered incorrectly three
times, there is a time-delay before the prompt
to enter the activation code appears again.
The time delay increases every time the
activation code is entered incorrectly, from
five minutes up to a maximum of five hours.
Installing map data
COMAND restarts the system immediately
before copying the data.
Navigation
187
COMAND
Z