Mercedes-Benz C-Class 2008 COMAND Manual - Manual (Page 140)

139
Navigation
Destination input
No stopover destination available yet
̈ Select a category.
A stopover destination exists
̈ To change: Select “Change Stopover”.
̈ Select a category.
̈ Select another stopover destination
Selecting a predefined category
COMAND first searches for destinations
along the route within the selected catego-
ry. COMAND then searches for destina-
tions in the vicinity of the vehicle’s
location.
If COMAND is unable to find any destina-
tions, a message to that effect will be dis-
played.
̈ Select “OK”.
̈ If necessary, select another category.
If COMAND finds destinations, a list is
displayed in the right-hand part of the
screen.
Here you will find the stopover destina-
tions in the selected category, sorted
by increasing distance from the current
vehicle location.
The list shows:
ț Name
ț Information on the location of the
stopover destination in relation to
the direction of travel and the
ț Current distance to the stopover
destination.
̈ To choose a destination: Rotate y m z
or slide q m r .
̈ To select a destination: Press n.
The Enter Destination menu appears
and displays the address of the desti-
nation.
̈ To cancel selection: Select “Back”.
̈ To start route calculation: Select
“Start”, see also (
୴ page 135).
Entering another destination as stop-
over destination
̈ If necessary switch to navigation mode
and display menu system
(
୴ page 118).
̈ Select “Destination” K “Stopover”.
̈ To enter: Select “OTHER”.
Choose from:
ț “Address Entry”
ț “From Memory”
ț “From Last Destinations”
ț “From POIs”
̈ Select a menu item.
The rest of the destination entry will vary
depending on the selection made:
For the “Address Entry” option see:
̈ Entering a destination via the address
(
୴ page 126).
For the “From Memory” option see:
̈ Entering a destination from the desti-
nation memory (
୴ page 135).
୴୴