Mercedes-Benz C-Class 2008 COMAND Manual - Manual (Page 155)

154
Navigation
Route guidance
The message “The driving instructions
have been muted” appears briefly.
̈ To switch navigation announce-
ments back on again manually: Se-
lect “Navi”
K 6.
or
̈ In the map display with the menu sys-
tem displayed (
୴ page 119) select
6.
or
̈ Start new route calculation
(
୴ page 135).
or
̈ If you switch COMAND on again or
start the engine.
̈ To set the volume of the announce-
ments: Set the volume during an auto-
matic announcement Setting the
volume (
୴ page 35).
or
̈ Call up an announcement manually us-
ing “Navi”
K 6 and set the volume
( ୴ page 35).
̈ In the map display with the menu sys-
tem displayed (
୴ page 119) select
“Destination” K “Cancel Route
Guidance”.
̈ In the map display with the menu sys-
tem displayed (
୴ page 119) select
“Destination” K “Continue Route
Guidance”.
COMAND calculates the route.
i
The Detour function blocks a route segment
ahead. You can set the length of the block.
COMAND calculates a detour route if possible.
̈ In the map display with the menu sys-
tem displayed (
୴ page 119) select
“Route” K “Detour”.
̈ To set length of block: Select
“Longer” or “Shorter” repeatedly until
the required length is set.
The blocked segment is highlighted in
red/white on the map. Shown at the
top of the display is the length of the
blocked segment and the route seg-
ment to which the block goes.
̈ To cancel the function: Select “Back”.
̈ To start route calculation: Select
“Start”, see also (
୴ page 135).
̈ To change a block: Select “Navi” K
“Route” K “Detour” K “Change”.
i
If a block already exists, the message “De-
tour Already Set” is displayed. You can then
change or delete this.
̈ Then set length of block.
̈ To delete block: Select “Navi” K
“Route” K “Detour” K “Delete”.
i
If a block already exists, the message “De-
tour Already Set” is displayed. You can then
change or delete this.
Cancelling route guidance
Resuming route guidance after
cancelling
Detour function