Rice Lake 880 Performance Series Panel Mount Indicator/Controller - EtherNet/IP Interface Option Installation and Programming Manual - Manual (Page 11)

Installation 7
2.2 EtherNet/IP Network Connections
To configure an IP Address, refer to Section 3.1 on page 6.
2.3 LED Status Indicators
Figure 2-10. EtherNet IP Module
Network Status LED (Item 1)
A test sequence is performed on this LED during startup.
Module Status LED (Item 2)
A test sequence is performed on this LED during startup.
LED State Description
Off No power or no IP address
Green On-line, one or more connections established (CIP Class 1 or 3)
Green, flashing On-line, no connections established
Red Duplicate IP address, FATAL error
Red, flashing One or more connections timed out (CIP Class 1 or 3)
Table 2-1. Network Status LED
LED State Description
Off No power
Green Controlled by a Scanner in Run state
Green, flashing Not configured, or Scanner in Idle state
Red Major fault (EXCEPTION-state, FATAL error etc.)
Red, flashing Recoverable fault(s)
Table 2-2. Module Status LED
Note
1
2
3
4
Note
Note