Rice Lake 880 Performance Series Panel Mount Indicator/Controller - EtherNet/IP Interface Option Installation and Programming Manual - Manual (Page 21)

Commands 17
4.2.3 Value
Weight data is returned to the master in the third and fourth words of the input
command format, depending on the command and the value type. The weight data
returned is the displayed weight after the command is executed, unless the command
specifies otherwise.
4.2.4 Setting a Float Value:
Setting a float value in a setpoint requires the value to be sent in two separate integer
values. Most PLCs have a mechanism to take a float value and separate it into to
integer values.
The following is what is needed in the output words to set the value of Setpoint #1 to
10000.
Command word = 304
Parameter word = 1
MSW = 17948
LSW = 16384
4.2.5 Reading a Float Value:
When a float value is read it will be retuned in two integers that will represent the
float value.
The PLC will need to combine MSW and LSW integer values back into a float value.
The following is what is will be returned in the input words if the weight on the scale
is 800.5.
Command Word = 288
Status word = Scale status
MSW= 17480
LSW = 8192
Word 2
Bit
Batch Function Status Data
Value=0 Value=1
00 Digital input 4 OFF Digital input 4 ON
01 Digital input 3 OFF Digital input 3 ON
02 Digital input 2 OFF Digital input 2 ON
03 Digital input 1 OFF Digital input 1 ON
04 Batch not paused Batch paused
05 Batch not running Batch running
06 Batch not stopped Batch stopped
07 Alarm OFF Alarm ON
08 Setpoint number
09
10
11
12
13 Not used
14 Integer data Floating point data
15 Positive weight Negative weight
Table 4-5. Batch Function Status Data Format