Rice Lake 880 Performance Series Panel Mount Indicator/Controller - EtherNet/IP Interface Option Installation and Programming Manual - Manual (Page 8)

4 EtherNet/IP Installation and Programming Manual
Retain the screws for installing boards to new backplate. Discard
existing backplate.
.
Figure 2-4. Boards Removed from Enclosure
9. Install the option card on the CPU board standoffs, plugging it into the J8
connector on the CPU board.
10. Secure with option card screws.
Figure 2-5. Install Option Card
11. Connect the CPU board and the power supply board to the new backplate.
Note
Backplate
Power Supply Board
Cable, Power
to CPU
CPU Board
Screws connecting power
supply board to backplate
Screws connecting CPU
board to backplate
Option Card
J8
Connector
Standoff
CPU Board
Option Card Screw