Rice Lake 880 Performance Series Panel Mount Indicator/Controller - EtherNet/IP Interface Option Installation and Programming Manual User Manual
Page 26
22 EtherNet/IP Installation and Programming Manual
Return Status and Current Weight as Float
Command: 256, 0x100
Parameter: Scale number
Command 256 returns the status and weight of the specified scale in floating-point
format, without changing the display. This command also causes the format-
independent commands to return a value in the floating-point format. Returns current
weight at a floating-point format.
Enter Tare as Float
Command: 268, 0x10C
Parameter: Scale number
Value: Tare weight
Command 268 enters a tare for the scale selected in floating-point format. The
indicator returns the tare weight as taken, or 0 for no tare.
Read Gross Weight as Float
Command: 288, 0x120
Parameter: Scale number
Command 288 returns the gross weight value for the specified scale in floating-point
format.
Read Net Weight as Float
Command: 289, 0x121
Parameter: Scale number
Command 289 returns the net weight value for the specified scale in floating-point
format.
Read Tare as Float
Command: 290, 0x122
Parameter: Scale number
Command 290 returns the tare weight value for the specified scale in floating-point
format.
Read Current Display as Float
Command: 293, 0x125
Parameter: Scale number
Command 293 returns the weight value for the specified scale as currently displayed
in floating-point format. This may include gross, net, tare, or accumulator values, as
enabled. The weight value is returned in the mode used to display a scale widget.
Read Accumulator as Float
Command: 294, 0x126
Parameter: Scale number
Command 294 returns the accumulator value for the specified scale in floating-point
format. Batch status is returned in place of the indicator status.
Set Setpoint Value as Float
Command: 304, 0x130
Parameter: Setpoint number
Value: Setpoint value
Command 320 sets the setpoint value for the specified setpoint in floating-point
format. This command is only valid if the setpoint is configured and requires a
setpoint value. Batch status is returned in place of the indicator status.