Rice Lake 880 Performance Series Panel Mount Indicator/Controller - EtherNet/IP Interface Option Installation and Programming Manual - Manual (Page 6)

2 EtherNet/IP Installation and Programming Manual
2.0 Installation
EtherNet/IP-specific functions are provided by an EtherNet/IP module. The module
plugs into an open option card slot on the CPU board and provides power and access
from the indicator bus to the EtherNet/IP Interface module.
This section describes the procedures used to install the EtherNet/IP Interface into the
indicator.
2.1 Installing the EtherNet/IP Interface
Figure 2-1. EtherNet/IP Interface Kit
Disconnect power before removing indicator backplate.
Use a wrist strap to ground yourself and protect components
from electrostatic discharge (ESD) when working inside the
indicator enclosure.
1. Disconnect indicator from power source.
2. Unplug all connectors from the back of the controller assembly.
PN 156669 Backplate, Controller
PN 152357 Module, Ethernet/IP
PN 153093 Option Card
Also included in kit:
PN 14825 Screw, Mach 4-40NC x 1/4" Qty 4
J1
J2
J4
WARNING
CAUTION