Rice Lake 920i Installation Manual V3.07 - Manual (Page 122)

116 920i Installation Manual
10.11 Audit Trail Support
Audit trail support provides tracking information for
configuration and calibration events. A separate
calibration counter is provided for each scale; a single
configuration counter tracks all configuration
changes.
To prevent potential misuse, unsaved configuration or
calibration changes are counted as change events;
restoration of the previous saved configuration or
calibration is also counted.
10.11.1 Displaying Audit Trail Information
To display audit trail information, press and hold the
Gross/Net key for several seconds. Various audit trail
information screens can then be accessed by pressing
the front panel number keys (
1–5 and 0 ). The exact
format of each screen depends on the regulatory
agency specified for the REGULAT (FEATURE
menu) parameter.
The initial screen shown when entering the audit trail
display (or whenever the
1 key is pressed while
showing audit trail information) shows the legally
relevant (LR) version number (software version for
the code that provides audit trail information), a
calibration count and, if REGULAT=NTEP, a
configuration count.
Press 2 to show the configuration count display. This
display shows the number of times the system has
been configured, the date and time of the last
config uration event, and the before and after
information for the most recent change of the system
date and time.
P r e s s t h e D o w n k e y t o s h o w t h e n u m b e r o f
weighments, number of configuration events, number
of calibrations, and the date and time of the most
recent calibration for the first configured scale.
Continue pressing the
Down key to cycle through the
information for all configured scales.
Press 3 to show the number and the most recent date
and time of power-on events, power-on configuration
changes, and user program loads.
Use the Down key to show the number of power-on
calibration events for all configured scales.
Press 4 to show the number of times the OEM version
number has been changed, and the date and time of
the most recent change.
Press 5 to show the number of times the configuration
has been reset, the date and time of the most recent
reset, and the indicator EIN number.
Press 0 to show the indicator and LR software
versions.
When done, press the Gross/Net key to exit the audit
trail displays.
10.11.2 Printing Audit Trail Information
Audit trail information can be printed by pressing the
PRINT key while displaying the audit trail or by
sending the DUMPAUDIT serial command. Audit
trail information is sent to the port specified on the
AUD.PORT serial command or by the AUDFMT
parameter (PFORMT menu).
NOTE: Printed audit trail information contains data for all
scales, whether configured or not, that can be supported by
the indicator. Displayed audit trail information shows data only
for currently configured scales.
long tons 2240.00 pounds
1016.05 kilograms
1.12000 short tons
1.01605 metric tons
troy ounces 480 grains
31.10348 grams
0.031103 kilograms
1.09714 ounces
0.068571 pounds
0.083333 troy pounds
troy pounds 5760 grains
373.2417 grams
0.373242 kilograms
13.16571 ounces
0.822857 pounds
12 troy ounces
Primary Unit x Multiplier
Secondary/
Tertiary Unit
Table 10-12. Conversion Factors (Continued)