Rice Lake 920i Installation Manual V3.07 - Manual (Page 27)

Configuration 21
3.2 Menu Structures and Parameter Descriptions
The 920i indicator can be configured using a series of menus accessed through the indicator front panel when the
indicator is in setup mode. Figure 3-1 summarizes the functions of each of the main menus.
The following sections provide graphic representations of the 920i menu structures and tables describing the
menu parameters. Default values are shown in bold type; numeric ranges and string values are shown in italic
type. Parameters shown surrounded by a dotted-line box only appear under the special circumstances explained
under each box.
Figure 3-3. Configuration Menu Flow
Menu Menu Function
SCALES Configuration Configure and calibrate scales.
SERIAL Serial Configure communications ports.
FEATURE Feature Set date and time formats, truck mode, passwords, keyboard locks, regulatory mode, and
initial consecutive number value, define softkeys and setpoint prompts.
PFORMT Print Format Set print format used for header, gross, net, truck in/out, setpoint, and auxiliary ticket formats.
See Section 6.0 on page 57 for more information.
SETPTS Setpoints Configure setpoints and batching mode.
DIG I/O Digital I/O Assign digital input/output functions.
ALGOUT Analog Output Configure analog output module. Shown only if analog output option is installed.
FLDBUS Fieldbus Configure fieldbus parameters for Profibus, DeviceNet, EtherNet/IP, and ControlNet
communications. Shown only if one of the listed fieldbus cards is installed.
VERSION Version Display installed software version number. The Reset Config softkey on the Version menu can
be used to restore all configuration parameters to their default values.
Table 3-1. 920i Menu Summary
SCALES SERIAL FEATURE PFORMT SETPTS DIG I/O ALGOUT VERS
Shown only if
Analog Output
card is installed
FLDBUS
Shown only if
Fieldbus card
is installed